Principle:
The oxidative-fermentative test determines if certain gram-negative rods metabolize glucose by fermentation or aerobic respiration (oxidatively). During the anaerobic process of fermentation, pyruvate is converted to a variety of mixed acids depending on the type of fermentation. The high concentration of acid produced during fermentation will turn the bromthymol blue indicator in OF media from green to yellow in the presence or absence of oxygen .
Certain nonfermenting gram-negative bacteria metabolize glucose using aerobic respiration and therefore only produce a small amount of weak acids during  glycolysis and Krebs cycle. The decrease amount of peptone and increase amount of glucose facilitates the detection of weak acids thus produced. Dipotassium phosphate buffer is added to further promote acid detection.
Uses:
OF Test is used to determine if gram-negative bacteria metabolize carbohydrates oxidatively, by fermentation, or are nonsacchrolytic (have no ability to use the carbohydrate in the media).
Media:
Hugh and Leifson’s OF basal medium; the constituents are as follows:
  • Sodium chloride : 5.0 g
  • Di-potassium phosphate : 0.3 g
  • Peptone : 2.0 g
  • Bromthymol blue:0.03 g
  • Agar: 3.0 g
  • Glucose : 10 g
  • Water : 1000 ml
The pH should be adjusted to 7.1 prior to autoclaving. After the medium is autoclaved at 121°C for 15 minutes, a filter sterilized solution of 10% solution of carbohydrate is aseptically added to the medium to a final concentration of 1%.
Procedure
  1. Inoculate two tubes of OF test medium with the test organism using a straight wire by stabbing “half way to the bottom” of the tube.
  2. Cover one tube of each pair with 1 cm layer of sterile mineral oil or liquid paraffin (it creates anaerobic condition in the tube by preventing diffusion of oxygen), leaving the other tube open to the air.
  3. Incubate both tubes at 35oC for 48 hours (Slow growing bacteria may take 3 to 4 days before results can be observed)
Interpretation
Acid production is detected in the medium by the appearance of a yellow color. In the case of oxidative organisms; color production may be first noted near the surface of the medium.
Oxidative Fermentative Test
Oxidative Fermentative Test
Following are the reaction patterns:
Open (Aerobic) TubeCovered (Anaerobic) TubeMetabolism
Acid (Yellow)Alkaline (Green)Oxidative
Acid (Yellow)Acid (Yellow)Fermentative
Alkaline (Green)Alkaline (Green)Non saccharolytic (glucose not metabolised)
  1. Fermentative result:  Acid production on both (open and covered) tubes. The acid produced changes the pH indicator, bromthymol blue, from green to yellow. e.g. Escherichia coli 
  2. Oxidative result: Acid production in the open tube (aerobic) and not the oil-covered tube (anaerobic) indicates an oxidative result. Nonfermenting bacteria that metabolize glucose via oxidative metabolism give an oxidative result. e.g. Pseudomonas aeruginosa 
  3. Non saccharolytic (Negative OF result): Nonsacchrolytic bacteria give a negative OF result. The negative result is indicated by no color change in the oil-covered tube and in some cases an increase in pH (pH 7.6) changing the bromthymol blue from green to blue in the top of the open tube. The increase in pH is due to amine production by bacteria that break down the peptone (protein) in the medium.
    e.g. Alcaligenes faecalis.
Quality Control
  • Glucose Fermenter: Escherichia coli
  • Glucose oxidizer: Pseudomonas aeruginosa
  • Nonsaccharolytic: Moraxella species

Related Posts:

  • Teicholic acid in bacterial cell wall Teichoic acids were discovered in 1958 by Armstrong and co-authors. The term teichoic acid encompasses a diverse family of cell surface glycopolymers containing phosphodiester- linked polyol repeat units. Teich… Read More
  • Differences between Exotoxins and Endotoxins differences between Exotoxins and Endotoxins Property Exotoxins Endotoxins Biomolecule/Chemistry Proteins Lipopolysaccharide-Lipoprotein complex  Location of genes  Plasmid or bacteriophage  Bacteria… Read More
  • Lipopolysaccharide (LPS) layer of Gram Negative Bacteria Lipopolysaccharide (LPS) Layer; the outer layer of cell wall of gram negative bacteria  is also called endotoxin.  It is a characteristics feature of Gram Negative Bacteria.  As in peptidoglycan biosynthesis… Read More
  • Bacterial Fimbriae (pili) Bacteria use adherence fimbriae (pili) to overcome the body’s defense mechanism and cause disease. Pili are small hairs that enable some pathogens to attach and adhere easily to cell surface particularly mucous membranes.… Read More
  • Pathogenicity islands of Human Pathogen The major properties of PAIs are as follows: 1.       PAIs have one or more virulence genes; 2.       PAIs are present in the genome of the pathogenic member … Read More

0 Comments:

Powered by Blogger.

Visitors

226089
Print Friendly Version of this pagePrint Get a PDF version of this webpagePDF


 download University Notes apps for android

Popular Posts

Flag Counter